DCT4 2.0 , alles fertig aber kein "Flash-Button" z

[patton747]

Hallo,

möchte mein handy flashen. hab ein DCT 4 Dongle , gepatche files,
userport, fia !

Dann gehe ich nach folgender Anleitung vor:
How to Flash MCU + PPM
1. Run 'WinDCT4.exe' found at "C:\Windows\Desktop\WinDCT4"
or the Desktop of your PC.
2. Click 'PPM File' button and then select the type of phone and
PPM file that you wish to use.
3. Connect phone to cable (phone must be powered off).
4. Click 'Flash' button and then quickly turn on the phone.
...Software will begin to erase then flash the MCU of the phone...
...Wait for approximately 3 minutes of more, then you will
see a message that says "Remove Battery, then click OK"...
5. Remove the cable from the phone and then put it back again.
6. Click 'OK' button and then quickly on the phone.
...Software will begin to erase then flash the PPM of the phone...
...Wait for approximately 30 seconds then phone flashing is done!
7. After flashing, you need to put a SIM card into the phone and
reset 'Factory Settings' using the phone's internal menu. Failure
to do this step will result to malfunctioning of Caller Groups.

Aber es erscheint kein "Flash-Button" neben PPM File.
Weis jemand Rat?

[bizepsandi]

hi,leider nicht...kenne nur die dct3 software... ist der button den grau hinterlegt?